What Is Sand Blasting? Commonly called abrasive blasting, grit or sand-blasting can be used to expose the aggregates inside a hardened concrete, giving it a rustic also attractive look, by eroding the surface layer. There are four typical grades of abrasion, with each one producing a matt finish featuring textures varying from these resembling sand-paper…
Why We Measure the Silt Content from the Sand? Silt content is a fine material that’s less than 150 microns. It’s unstable in the presence of water. It’s unstable in the presence of water. If we utilize silty sand for bonding, it will reduce the strength and cause rework. You could be experienced this while…
What Is Bleeding In Concrete? Bleeding in concrete is sometimes referred to as water gain. This is a special form of separation, in which some water from the concrete flows to the surface of the concrete, with the lowest specific gravity among all concrete components. Excessive bleeding is seen in thin members such as roof…
What Is Waterproofing? This is the process of making a structure water-resistant or impervious to the ingress of water. Water-Proofing is essential that prevents water from penetrating buildings and also helps to keep the inside areas dry. It helps in reducing the humidity inside the building, minimizing the damage done to furniture and alike. In…
What Is Carpet Area? Carpet area means it is an accurate area that can freely be covered by a carpeted inner a house and is the area of the house, excluding the thickness of the inner walls. If you had to lay out a wall-to-wall carpet in your entire house, the chosen area covered would…
Introduction of Arches Construction An Arch is basically a structure that is constructed of a wedge-shaped unit. The inner curve of an arch is known as Intrados and the outer curve of the arch is known as Extrados. The main function of the arches is to support the load of the portion of the wall…
What Is Veneer? A veneer is a very thin piece of wood that is attached to particleboard or other types of manufactured wood. Veneers are used to lessen the cost of a project without sacrificing the overall appearance. It may be attached using an adhesive, nails, or screws. Veneers are frequently used on cabinets, furniture,…
What Is Fresh Concrete? When concrete is its plastic state, it is known as fresh concrete. Fresh concrete can be easily molded to a durable structural member. It can be prepared on the spot and may give a wide range of properties from easily available raw materials. Properties of Fresh Concrete Workability. Temperature. Water Cement…
What Is Slump Cone Test? A Slump cone test or concrete Slump test is to determine the workability or consistency of the concrete mixture prepared in the laboratory or at the construction site during the course of work. A concrete Slump test is performed from batch to batch to check the uniform quality of the…
What Is Foundation Repair? Foundation renovation is required when the foundation of a home, building, or structure is impaired & the core structure of the building is required to be repaired. Foundation Techniques 1. Sealants & Masonry Patches Cracks are required to be identified & renovated as early as possible by patching & sheathing with…