What Is Stone? Stones were some of the essential construction materials in civil engineering. Stones are formed of rocks that comprise the crust of the earth and therefore have no regular shape or chemical composition and are mixes of 2 or even more minerals. The mineral is a material produced by an inorganic materials mechanism…
Introduction of Coarse-Grained Soils Vs Fine-Grained Soils Soil is one of the most important components which should be check and tested before doing any kind of construction on the site. As a civil engineer, it is very necessary that you should know the difference between coarse-grained soils and fine-grained soil so that you can design…
Introduction of Calculate Steel in Rcc Slab The slab is one of the most important structural elements in the construction of buildings. Many of us are confused that how to calculate steel in RCC slab. In this article, we will get to know about the step-by-step procedure to calculate steel in RCC slab. A slab…
What Is Vacuum Concrete? Vacuum concrete is that type of concrete where the extra water is removed for increasing the strength of concrete. A small part of concreting part is constructing by vacuum concrete of slab and walls; then, we need to maintain the water-cement ratio 0.5-0.65. If we remove the excess water and air…
What Is Earthen Dam? The dam which is constructed fulfilled by the earth is known as the earthen dam. The earthen dam is constructed by different layers of soil. The layers of the soil of the earthen dam are then compacted by sheep’s foot rollers, tamping rollers, heavy pneumatic tired rollers, earth-hauling equipment, or vibratory…
What Is Inverted Arch Footing? The Inverted Arch Footing is built in areas where the carrying or bearing capacity of the soil is very low and the load of the building is concentrated on the walls and digging is not possible. This is not a typical type of foundation. Inverted Arch Footing is built between…
Introduction of Structural Loads Structural analysis is a salient feature of a design of buildings as structural loads can typically cause stress, deformation, and displacement which might result in structural failure. What Are Structural Loads? Loads are generally the forces that can cause stresses, deformations, or accelerations. There are an ample range of distinct kinds…
Definition of Kelly Clamp Kelly clamp is defined as a vertically movable pinch clamp fastened to a graduated stick to allow the interpretation of the penetration depth of the kelly ball. These are clamped only at top of the device prior to the experiment then dropped to interact with the edge of the tower until the…
What Is Composite Masonry? Composite masonry is the one that is constructed out of two or more types of building units or of different types of building materials. When walls are constructed with two or more types of building materials it is term as composite masonry. It makes the used of locally available materials to obtain…
What Is a Concrete Surface Retarder? Surface retarders, also know surface “deactivators,” are applied to fresh concrete to chemically delay the set of the surface mortar. Unlike concrete set retarders, they allow the rest of the concrete to cure normally, without affecting the setting rate or strength gain. Because surface retarders work their magic by…